What To Do If It Goes Wrong - Vax Dust & Vac Cordless HF86-DV-B Instructions Manual

What to do if it goes wrong

Problem
Is there an
accessory missing?
Why won't my Dust &
Vac turn on?
Why won't my Dust &
Vac pick up?
Dust escaping from
the Dust & Vac
CAUTION: To reduce the risk of personal injury, unplug the Dust & Vac from charger before performing
maintenance/troubleshooting checks.
HF86-DV-B_Dust&Vac_Cordless_UG_[J1331]_PRINT_171014.indd 10
Solution
• Check the 'This pack contains' panel on the box to make sure the part is
included with your machine.
• Ensure the handle is fitted correctly and pushed fully on to the main body.
• Battery may not be fully charged. If using the Dust & Vac for the first time
the initial charge should be 24 hours. The charging light will illuminate
when charger is connected and charging, once fully charged the
illuminating light will go out
• Empty dirt container, remove and wash filter allowing
24 hours to dry before refitting.
• Dirt container may not be fitted correctly. To refit the dirt container tilt so that
the bottom aligns first, and then gently push until it locks into place.
• Poor suction can be caused due to battery power becoming low and may
need to have a full re-charge.
• Clear any blockages from the machine.
• Dirt container may be full and may need to be emptied.
• Filter may need to be washed please allow 24 hours to dry before refitting.
• Clear any blockages from the machine.
.
21/10/2014 10:52