Table of Contents
Advertisement
Remark: If the Configuration file is uploaded as above to the Convexs/Invexs, no checks are made if this
configuration file is suitable for this Convexs/Invexs. This is in contradiction with the use of the Configuration
card (then only specific cards with specific keys can be used to program these Convexs/Invexs).
7.2.
Configuration card
The configuration made with AEreco can be stored on a configuration card. By presenting this configuration card
to a new Convexs/Invexs (default, factory settings) the settings on the configuration card are programmed into
the Convexs/Invexs reader. Up from now only these specific unique configuration cards can be used to program
the configuration in the corresponding Convexs/Invexs readers.
During the configuration process the beeper will sound, to indicate the configuration is loading (and the card
should not be taken away from the Convexs/Invexs). This process takes about 5 seconds.
The uniqueness of the combination of Configuration card and Convexs/Invexs is made with the Reader read key
that is determined at AEreco (General – Configuration card). This Reader read key is also stored in the
Convexs/Invexs and every following time a Configuration card is offered, this Reader read key is compared
against this key of the Configuration card. This principle results that only Configuration cards with the same
Reader read key can change the configuration of a Convexs/Invexs. This key is independent of the Mifare keys.
8.
Updating firmware of the Convexs/Invexs
If new firmware must be loading into the Convexs/Invexs reader this can be done by:
• Using AEmon, the Convexs/Invexs is connected to the AEOS reader AEpack (APx003rs485NR or
APx003rs485NR2, the Convexs/Invexs must have the RS485NR output protocol).
At AEmon in the Hardware view the connected Convexs/Invexs reader(s) are available. Selecting now
these Convexs/Invexs reader(s) gives the opertunity to load a new firmware
Using AEmon all connected Convexs/Invexs readers can easily be updated with new firmware.
• Connect the Convexs/Invexs directly to AEreco (RS485) and load the new firmware direct to this
Convexs.
Remark: After updating the firmware the configuration must be reloaded. Updating the firmware will
automatically remove the configuration.
9.
Default settings of the Convexs/Invexs
Default settings (factory settings, NR9000.cfg) of the Convexs/Invexs are:
• Mifare reader enabled, Mode: CSN
• Conversion table
Input Type
Nedap XS
Nedap XS
Mifare CSN
Mifare CSN
• Beeper: No NA / UL beep
• Led Mode: Red / Green
• Preferred Card Type: Nedap XS Card
• Configuration card enable
• Reader read key: FC9011EE5339
With this default configuration (file NR9000.cfg and NR9001.cfg) the Convexs/Invexs acting for XS cards as a
normal antenna, and can be connected to AEpacks (on RS485NR) or Nedap reader AEpacks (with AX1014) or
XS readers (with AB350).
© Nedap N.V.
(CSN reversed: NR9001.cfg)
Output Type
RS485NR
Nedap RF badge
RS485NR
Nedap RF data
Nedap Readers Installation Guide
Page 18 of 21
Hide quick links:
Advertisement
Table of Contents
