Table of Contents
Advertisement
6.4.
Unresponsive board
If your LinkIt Connect 7681 development board becomes unresponsive:
1) attempt to reboot the board using either AT#Reboot or the hardware reset button (see
Figure 25).
2) reload the recovery firmware using the uploader.
3) reload the recovery firmware using a Flash Programmer (for more information on Flash
Programmers see section 3.3, "Additional tools").
4) contact
Seeed Studio
Remember also to check the Labs
This document contains information that is proprietary to MediaTek Inc.
Unauthorized reproduction or disclosure of this information in whole or in part is strictly prohibited.
MediaTek LinkIt™ Connect 7681 Developer's Guide
support.
Forums
for posts on possible causes and cures.
© 2015, 2016 MediaTek Inc.
Page 57 of 65
Advertisement
Table of Contents
