Getting Started; Charging And Installing The Battery Pack - Sony CCD-TRV19 Operation Manual (primary manual) Operation Manual

Getting started

Charging and installing the battery pack

Before using your camcorder, you first need to charge and install the battery pack. To
charge the battery pack, use the supplied AC power adaptor.
Charging the battery pack
Charge the battery pack on a flat place without vibration.
(1) Connect the AC power adaptor to the wall outlet.
(2) Align the right side of the battery pack with the line on the AC power adaptor,
then slide the battery pack in the direction of the arrow.
(3) Set the selector to CHARGE. The CHARGE lamp (orange) lights up. Charging
begins.
When charging is completed, the CHARGE lamp goes out. Unplug the unit from the
wall outlet, and then remove the battery pack and install it on the camcorder.
1
Charging Time
NP-33(supplied)
Battery pack
Charging time*(min)
*Approximate minutes to charge an empty battery pack using the supplied AC power
adaptor. (Lower temperatures require a longer charging time.)
Battery life
CCD-TRV11/TRV19/TRV119
Battery pack
NP-33(supplied)
LCD open 2)
While
recording 1)
LCD close
While playing back on
LCD 3)
6
2
NP-55 NP-98/98D NP-80/80D
70 215 190
60
NP-55 NP-98/98D NP-80/80D
75 (40) 225 (120)
70 (30) 200 (110)
95 (55) 305 (170)
90 (45) 265 (150)
75 225
65 195
CCD-TRV11/TRV19/TRV21/TRV29/TRV119/TRV211 3-810-780-23.E
3
POWER CHARGE
NP-60D
NP-66 NP-C65
NP-68/66H
90
95 105
125
NP-68/66H NP-66 NP-C65
NP-60D
110 (60)
140 (75) 120 (65) 100 (55)
180 (100) 150 (85) 155 (85) 135 (75)
110
140 115 100