6 Disassembly TH-37PR10U
· To disassemble P.C.B., wait for 1 minute after power was
off for discharge from electrolysis capacitors.
·
and
marks indicate screw positions.
6.1.
Removal of Rear Cover
1. Remove screws (×6
, ×6
remove the Rear Cover.
6.2.
Removal of Slot Block
1. Disconnect the connectors (DS1, DS4, DS6, DS7).
2. Remove 4 screws and then remove the Slot Block.
3. Disconnect the connectors(DS2, DS8, DS15).
, ×14
, ×8
) and then
6.3.
Removal of DS-Board
1. Remove the Slot Block.
(Refer to Removal of Slot Block)
2. Disconnect the connector(DS14).
3. The Slot Block is turned inside out.
4. Remove 6 screws and then remove the Slot Cover.
5. Remove 6 screws and then remove DS-Board.
9
TH-37PR10U / TH-42PR10U