Table of Contents
Advertisement
8 Disassembly and Assem-
bly Instructions
The important matter at the time of electronic pen
exchange
• Please register electronic pen, when electronic pen is
exchanged.
• There is a maximum in electronic pen's number of registra-
tion.
The important matter at the time of electronic pen adapter
exchange
• Since electronic pen's registration information is memorized
by the electronic pen adapter, in electronic pen adapter
exchange, re-registration of electronic pen is required for it.
(It is unrelated in the registration information, A-Board, and
the main part of a display of an electronic pen)
The important matter in the case of exchanging modules
• To disassemble P.C.B., wait for 1 minute after power was off
for discharge from electrolysis capacitors.
• Please remove the clamper and tape of cables beforehand.
•
,
,
,
,
and
marks indicate screw positions.
8.1.
Removal of Rear Cover
1. Remove screws (17×
then remove the Rear Cover.
8.2.
Removal of Slot Block
1. Disconnect the connectors (DS13, P9), and remove the
flexible cable from the connector (DS1).
2. Remove screws and then remove the Slot Block.
, ×23
) and M8 Cap (×4
8.3.
Removal of DS-Board
1. Remove the Slot Block.
(Refer to Removal of Slot Block)
2. Turn over the Slot Block.
3. Remove the screws and then remove DS-Board.
8.4.
Removal of HX-Board
1. Disconnect the connector (A37).
2. Remove 4 Hexagonal-Head screws, 4 screws ( ) and 1
) and
screw ( ) and 1 screw ( ) and then remove the HX-
Board Block.
3. Turn over the HX-Board Block.
4. Disconnect the connector (HX1).
29
TH-50PB2E
Advertisement
Table of Contents
