Table of Contents
Advertisement
7 Disassembly and Assembly Instructions
7.1.
PCB Layout
7.2.
Preparation
Please pull soft cloth etc. not to damage a screen and please
turn the front of a main part down and lay it down
7.3.
About
replacement
Cautions when replacing each component
• When you replace each component, please be sure to carry
out according to the following procedure.
• When you attach each module, please do not bolt a screw
strongly.
• The part without the statement of tightening torque, please
tighten a screw 50 - 70 [N cm].
• To disassemble P.C.B., wait for 1 minute after power was off
for discharge from electrolysis capacitors.
• When tightening a screw, retention structures are required
not to deform the LCD Panel.
• Please remove a clamper and a wire processing tape if
needed in the repaire.
• Hold the specified parts to stand the monitor up. (Prevent
from the curvature and deformation of a set)
19
TH-50LFE6W
disassembly
and
Advertisement
Table of Contents
