Using The Built-In Light - Sony CCD-TR78 Operation Manual (primary manual) Operation Manual

Using the Built-in Light

You can use the built-in light to suit your shooting situation. The recommended distance between
the subject and camcorder is about 5 feet (1.5 meters).
While the camcorder is in Standby mode, slide LIGHT to ON. The built-in light turns on.
Turn STANDBY down to turn off.
To Turn On the Built-in Light Automatically
Slide LIGHT to AUTO.
The built-in light automatically turns on and off according to the ambient brightness.
However, if the built-in light turns on for more than about 5 minutes, it automatically turns off. In
this case, turn STANDBY down once and turn it up again.
Notes
• The battery pack is quickly discharging while the built-in light is turned on. Slide LIGHT to OFF
when not in use.
• When putting the camcorder into a bag, slide LIGHT to OFF and remove the battery pack to avoid
turning on the built-in light.
• If the built-in light is turned on when the battery is weak, the battery may be used up quickly.
• Flickering may occur when you shoot white and bright subjects in AUTO mode.
• The built-in light may turn on/off when you use the PROGRAM AE or BACK LIGHT function.
• When using a marine pack or sports pack (not supplied), slide LIGHT to OFF.
CAUTION
Be careful not to touch the lighting section, because the plastic window and surrounding
surfaces are hot while the light is on. It remains hot for a while after the light is turned off.
DANGER
Not to be handled by children.
Emits intense heat and light.
Use with caution to reduce the risk of fire or injury to persons.
Do not direct light at persons or materials from less than 4 feet (1.22 meters) during use and
until cool.
Slide LIGHT to OFF when not in use.
22
CCD-TR78/TR88/TR98 3-810-917-13.E