Panasonic CW-A90VE Service Manual page 11

3. Slide the chassis back into the cabinet. Reinstall the cabinet
screws. Secure the cabinet to chassis by using screws
(from rear cabinet).
Depending upon the location of the AC outlet, route the AC
cord to either the left or right side while installing the front
grille.
4. Attach the front grille to the cabinet and fasten it with
screw s.
5. Insert the air filter.
6. Slide the front intake grille slightly to the right to reattach the
tabs and then push it down to close tight.
8.4. Removal of Front Grille
1. Remove the front intake grille.
Pull up the front intake grille about 90° and slide it slightly to
the left to unhook the tabs.
CAUTION
Do not raise the front intake grille any higher than 90° to the
unit or damage to the tabs may occur.
2. Remove the air filter.
Tilt up and pull out the air filter by the holder.
3. Remove the front grille.
a. At bottom right side of the front grille, press inward on
cabinet near the power cord, and pull the grille outward
to the right until right tab releases.
b. At the bottom left side, push inward on cabinet and pull
the grille outward to the left to release the left tab. Do
not pull the bottom edge toward you more than 3 inches
to prevent the two top tabs from damage.
c. Slide the front grille upwards to free the two top tabs
from slots at the top of the cabinet.
11
CW-A90VE / CW-A120VE