Controls And Indicators - Care Fusion Alaris GW Directions For Use Manual

Controls and Indicators

Controls
Symbol Description
ON/OFF button - Press once to switch the pump ON. Press and hold down for approximately 3 seconds to
a
switch the pump OFF.
d
RUN/HOLD button - Press to start the infusion or to put the infusion on hold.
CLEAR/SILENCE button - Press to silence alarm for 1 minute. The alarm will resound after this time. Resets
c
numeric values to zero.
b
PRIME/BOLUS button - Primes the Infusion set. Administers bolus during the infusion.
PRIMARY/SECONDARY button - Switches the pump between Primary and Secondary infusion modes. (If
l
enabled).
ENTER button - Scrolls between rate, time, VTBI and total volume infused (VI). Enters values for selected infusion
e
/ configuration parameters. Confirms the rate during an infusion titration.
CHEVRON keys - Increases or decreases the infusion rate, TIME limit and VTBI. Press and hold to increase the
hf
selection speed. Used to adjust user selectable options
Indicators: (when illuminated)
Symbol Description
AC POWER indicator - When illuminated the pump is connected to an AC power supply.
S
RATE
The pump is displaying the infusion rate in millilitres per hour (ml/h).
VTBI The pump is displaying the Volume To Be Infused (VTBI) in millilitres (ml).
VI The pump is displaying the Volume Infused (VI) in millilitres (ml).
TIME The pump is displaying the infusion time in hours : mins.
MICRO
The pump is operating in the MICRO Mode. When not illuminated the pump is in the STANDARD Mode.
SEC The pump is operating in the SECONDARY Mode. When not illuminated the pump is in the PRIMARY Mode.
(Millilitres / hour) When ml is illuminated the pump displays the rate, VTBI or VI. When the hr is illuminated the
ml/hr
pump displays the rate or infusion time.
1000DF00430 Issue 4
Alaris® GW Volumetric Pumps
Controls and Indicators
4/36