Miele DGC 7660 Operating And Installation Instructions page 21

FlexiClip runners HFC 71
The FlexiClip runners can be attached
to any shelf level.
Push the FlexiClip runners fully into
the oven compartment before placing
accessories on them.
The accessories will then automatic-
ally sit securely in between the stop-
pers at either end of each runner and
be prevented from sliding off.
The FlexiClip runners can support a
maximum load of 15 kg.
Guide to the appliance
Fitting and removing FlexiClip run-
ners

Risk of injury caused by hot sur-
faces.
The steam oven gets hot during op-
eration. You could burn yourself on
the heater elements, oven compart-
ment, side runners or accessories.
Allow the heater elements, oven
compartment, side runners and the
accessories to cool before fitting or
removing the FlexiClip runners.
The FlexiClip runners are fitted in
between the two rails that make up a
shelf level.
The FlexiClip runner with the Miele logo
should be fitted on the right.
When fitting or removing the FlexiClip
runners, do not extend them.
 Hook the FlexiClip runner onto the
front of the lower rail of a shelf level
(1.) and then push it along the rail into
the oven compartment (2.).
21