Installation; Surface-Mounted Installation - Miele KM 7678 FR Operating And Installation

Installation

Surface-mounted installation

 Create the worktop cut-out. Remem-
ber to maintain the minimum safety
distances (see "Safety distances").
 Seal any cut surfaces on wooden
worktops with a special varnish, sil-
icone rubber or resin to prevent the
wood from swelling as a result of
moisture ingress. The sealant must
be heat-resistant.
Make sure that the sealant does not
come into contact with the top of the
worktop.
 Stick the supplied sealing strip under
the edge of the hob. Do not apply the
sealing strip under tension.

Risk of damage from incorrect
connection.
The hob electronics may be dam-
aged if a short-circuit occurs.
The mains connection cable must be
connected to the hob by a qualified
electrician.
 Connect the mains connection cable
by following the instructions in the
wiring diagram on the hob (see "Elec-
trical connection" – "Wiring dia-
gram").
 Feed the mains connection cable for
the hob down through the worktop
cut-out.
 Place the hob centrally in the cut-out.
When doing this, make sure that the
seal of the appliance sits flush with
the worktop on all sides. This is im-
portant to ensure an effective seal all
round.
64
If the seal does not meet the worktop
correctly on the corners, the corner ra-
dius (≤ R4) can be carefully scribed to
suit.
 Connect the hob to the mains (see
"Electrical connection").
 Check that the hob works.