Makita HM1810 Manual page 20

W
iring diagram
[2] Wiring in Cap Cover
1) First, if Noise suppressor is used, in order to protect lead wires, stick Sponge sheet to the surface A of Cap
cover so that the longer side of Sponge sheet contacts the surface B of Cap cover and the shorter side
contacts the surface C. (Fig. 58)
Fig. 58
Cap cover
Sponge sheet
2) Then connect the lead wires as illustrated in Fig. 59.
Fig. 59
Noise suppressor
Crank housing cap
Field lead wires (black)
Lead wires of Noise suppressor (white)
(if Noise suppressor is used)
Lead wires of Pilot lamp
Lead wires of Lead unit
Relay wires to Switch (red)
Important
Be sure to connect the lead wires
after routing through the opening of Cap cover.
After connecting the lead wires, put Connector,
Insulated connectors and the slack of lead wires
into the opening of Cap cover as illustrated
to right.
Sponge sheet
shorter side
longer side
Connector
Cap cover
If Noise suppressor is used, be careful not to move
Noise suppressor out of place when connecting
these lead wires with the insulated connector.
Surface A
Surface C
Surface B
Rear case
Top cover
Opening of Cap cover
P 20/ 20
Handle sub base