Prep To Replace Water Seal Or Bearings - Scotsman UF424A-1A Technical Manual

UF424 / UN324 Technical Manual

Prep to Replace Water Seal or Bearings

It is the manufacturer's recommendation that the top
bearing, bottom bearing and water seal be replaced at
the same time.
Extruder / Breaker
1. Remove top panel.
2. Slide chute cover back and remove.
3. Unscrew ice sweep.
4. Lift up and pull ice chute off evaporator.
5. Remove four 1/4 inch hex head socket screws.
6. Lift breaker off auger.
Auger
1. Shut water off to machine.
2. Drain reservoir.
3. Disconnect electrical power.
4. Remove top panel.
5. Unscrew ice sweep.
6. Lift up and pull ice chute off evaporator.
Electrical Shock Hazard
Disconnect electrical
power before beginning
September 2017
7. Remove four 1/4 inch hex socket head socket
screws.
8. Return ice sweep to auger.
9. Lift on ice sweep to remove auger.
10. See Replace Water Seal and Auger Bearings
Page 30