Replace Fan Motor - Scotsman UF424A-1A Technical Manual

UF424 / UN324 Technical Manual

Replace Fan Motor

Suggested tools include 1/4 inch drive ratchet set.
The fan motor is located behind the front panel.
1. Remove the front panel.
2. Disconnect electrical power.
3. Unplug motor from power harness.
4. Remove bolts (3/8 inch head) holding fan motor
brackets to condenser.
5. Remove screws (1/4" head) holding fan motor to
brackets.
Note: Fan blade is marked "Nut Side" for correct
positioning on motor. Air flow direction is pull thru the
condenser.
Replace condenser
The deck cover cannot be removed without
disconnecting ice making system from the
refrigeration system. The condenser must be replaced
from the front.
Begin by taking the fan motor, blade and brackets off
the condenser.
Then, from the front, remove the screw holding the
condenser to the base.
Next, locate an access hole in the deck above the
back condenser fastener. Remove that screw.
Electrical Shock Hazard
Disconnect electrical
power before beginning
September 2017
Page 22