Sony 500WSPL Operating Instructions Manual page 81

Basic menu page 2
mSKIN DTL: OFF
DL LEV
PRE WHT : 3200
Item Settings
SKIN DTL 0.0 to 0.5 (normal value) to 1.0
Sets the amount of Smaller values set a softer skin detail.
skin detail
correction.
DL LEV LOW, STD (normal value), HIGH
Sets the Set the amount of DynaLatitude
DynaLatitude level. effects as high level, standard level
(STD), or low level.
When the filter is 3200 or CROSS:
PRE WHT
Sets the color 2200 to 3200 (normal value) to 4300,
temperature of the filter 5600K, 5600K + 1/8ND
When the filter is 5600K + 1/64ND:
preset white
4600 to 5600 (normal value) to 12000
balance.
Basic menu page 3
This is displayed when the SETUP switch has been set
to FILE.
F I L E : * F L
mS E L E C T F I L E
H I S A T
C H G F I L E
( Y E S mP U S H )
For details of this operation, see "Setup Files" (page 94).
Basic menu page 4
This is displayed when the optional DSBK-501/501P
Analog Composite Input Board is fitted to the
camcorder.
mVIDEO IN: CAM
: STD
Item Settings
CAM (normal value)
VIDEO
Records the signal shot by this camcorder.
IN
Selects
EXT
the
Records the signal input from the GEN LOCK IN/
signal
VIDEO IN connector. The image on the
to be
viewfinder and the signal output from the
recorded
MONITOR OUT connector are switched to the
onto the
external video signal. When inputting the external
internal
video signal, "EXT INPUT" blinks on the screen.
VCR.
EXT INPUT
If you set VIDEO IN to EXT and input the external VBS
signal from the GEN LOCK IN connector, the image in
the viewfinder and the signal output from the
MONITOR OUT connector are switched to the external
video signal. When inputting the external video signal,
"EXT INPUT" always blinks on the screen.
Notes
• When VIDEO IN is set to EXT, the video signals are
not output from the S VIDEO OUT connector.
• When VIDEO IN is set to EXT, the basic menu page
5 is not displayed.
Basic menu page 5
This menu is displayed when CAM is selected on the
basic menu page 4 and an external sync signal is input
to the GEN LOCK IN connector.
mSC PHASE: 000
H PHASE: 135
Item
SC PHASE
Sub carrier phase adjustment for
when the camcorder is genlocked. a)
H PHASE
Horizontal phase adjustment for
when the camcorder is genlocked. a)
a) This applies when using an external sync signal to
synchronize operation of several camcorders (see page 44).
Chapter 4 Viewfinder Screen Indications and Menus
Settings
000 to 999
000 to 135 (normal value)
to 199
81