Menu 210 Using Auto-Check Function - Sony 500WSPL Operating Instructions Manual

Sony digital camcorder operating instructions dsr-500wsl, 500wspl
Table of Contents

Advertisement

Example: 8 minutes
207 08
Blinking
Standby-on period
If the setting does not need to be changed, press
the MENU button to close the menu.
2
Press the SHIFT button until the standby-on period
starts blinking, then press the ADVANCE button.
Each press of the ADVANCE button changes the
setting as follows.
08 (factory setting) t 01 t 03 t 05
3
Press the RESET/(MENU SET) button and then
the MENU button.
The settings are recorded and the display window
returns to the display shown before the VCR menu.
Using Auto-Check
Menu 210
Function
On the DSR-500WSL/500WSPL, the internal check
can be automatically performed using the auto-check
function. Meanwhile, a test recording and playback are
also performed for about one minute.
Before shooting, it is desirable to perform auto-check
and make sure for problems in VCR's internal
operations through the result of the internal check
displayed in the display window and the video and
audio recording qualities.
Preparations for testing
Make preparations as shown in the table below.
Preparation
Connect a monitor to the MONITOR OUT or S
VIDEO OUT connector
Connect an earphone or headphones to the
EARPHONE connector
Prepare a cassette for test recording/playback Page 53
To perform the auto-check
1
Display menu 210.
210
Blinking
2
Press the SHIFT button to make the auto-check
function indication (oFF) start blinking, then press
the ADVANCE button to change the indication to
"on".
To cancel the auto-check function, press the
MENU button to close the menu.
3
Press the RESET/(MENU SET) button.
This changes the display and opens the cassette
holder. If there is a cassette in the holder, it is
ejected (except during recording).
At EJECT n At
4
Insert the cassette and close the cassette holder.
The display changes to the following, and the tape
is loaded.
5
Use the tape transport buttons to change the tape
position for test recording if necessary, or advance
to step 6.
Refer to
Page 25
Page 15
oFF
Auto-check function
indication
C-In
Blinking
At
rEC
Blinking
Chapter 5 Adjustments and Settings
(Continued)
107

Advertisement

Table of Contents

Troubleshooting

loading

This manual is also suitable for:

Dsr-500wslDsr-500wspl

Table of Contents