BMS F-16C/D 4.34 Flight Manual page 90

T.O. BMS1F-16CM-1
Depressing OSB #5 enters the CNTL page:
1.4.5.4 Selective Jettison (S-J) page:
released the highlighted stations are removed from the S-J page and the associated weapon quantity
reads zero. The S-J mode also bypasses any other weapons settings
BMS 4.34 Dash 1
© Red Dog 2012-2019
When the A-A CNTL page is selected OSB #5 CNTL is
highlighted.
There is not much to set here, except perhaps the MSL ID which
should match your flight # ID. It is good practice to set your MSL
ID to #2 for instance if you fly as wingman in a two ship.
This would serve the FCR datalink should it be implemented one
day. For the moment it is not implemented in BMS.
The S-J page is accessible in NAV, A-G and A-A modes from
the SMS base page OSB #11.
Selective Jettison is a Master Mode.
This allows the pilot to jettison weapons and racks unarmed or
unguided from selected aircraft stations. Only jettisonable stores
will be displayed for selection. The pilot presses the OSB
adjacent to the station displayed on the S-J page. The selected
station's bottom-most store is highlighted on the S-J page,
indicating that it is selected. If a jettisonable rack is also loaded it
may also be selected with a second press of the OSB. A third
press will then deselect all stores on that station. The pilot can
preselect a selective jettison configuration while in S-J Master
Mode, which will be remembered during Master Mode
transitions. The stores are jettisoned using the pickle button
when the MASTER ARM switch is in ARM. After the stores are
BMS 4.34 Change 2.00
.
Page: 90