Troubleshooting; Specifications - Panasonic EW1611 Operating Instructions Manual

Troubleshooting

Problem Possible cause
The nozzle is clogged.
No water comes
out, or water jet
The outlet of nozzle
power down.
is squashed.
The nozzle comes The nozzle is
off during use. deformed.
The power plug is
pulled out from the
Fail to remember
household outlet
the water pressure
before the power
level.
switch "
off.
Motor sound
changes after the This is not an abnormality. Please use the
Stop/Jet switch is product as usual.
set to " " (Stop).
Takes 10 minutes
after switch on.
Water jet stops
The self-protection
during using.
function is
activated due to a
thunderstorm etc.
The water pressure
level LED indicator This is not an abnormality.
still flashes after
The indicator will be off after 1 minute of
the power switch turning off.
" " is turned off.
If the problems still cannot be solved, contact the store where you
purchased the unit or a service center authorized by Panasonic
for repair.
PB014381 - EW1611W451 (01EN)_03-01-17.indd 11
Action
Replace the
nozzle.
Before pulling
out the power
plug from the
household outlet,
turn off the power
" is turned
switch " ".
This is not an
abnormality.
(See page 8)
Turn on the
power switch
" " again.

Specifications

See the name plate on the product
Power Source
(Automatic voltage conversion)
Power
18 W
consumption
Date of
See engraving on the commodity
production
Water tank Approx. 600 mL (the water pressure level
volume "10", 115 seconds)
Main unit:
280 (H) × 125 (W) × 140 (D) mm
Dimensions (Including nozzle)
200 (H) × 125 (W) × 140 (D) mm
(Not including nozzle)
Suction hose
Approx. 1100 mm
length
Mass Main unit: Approx. 940 g (Including nozzle)
This product is intended for household use only.
11
2017/3/1 8:59:48