Converting Slim-Tube To Standard Fit; Standard Fit Eartip & Tubing - Hearing Help Express Apollo-6205 Falcon User Manual

1
To convert your Apollo from a slim-tube style to the standard fit behind-the-ear
refer to page 5 for instructions on removing the slim-tubing.
2
After you have removed the slim-tube, line up the nozzle
on the end of your Apollo with the earhook exactly as shown.
Push the two parts together until the earhook snaps in place.
Eartip & tubing for standard fit style
Your Apollo hearing aid comes with a selection of silicone
eartips and a pre-cut and full-length elbow joint tubing.
Pre-cut elbow joint tubing
The fit of your hearing aid is very important.
Try the different sizes of eartips until you find one that is secure and comfortable.
How to attach eartip:
1
If the pre-cut tubing is too short or too long, follow the directions
below using the full-length elbow joint tubing enclosed.
How to measure and attach the full-length tubing
1
1. Put eartip and
Apollo in place
Place the eartip
with attached tubing
in your ear and the
hearing aid over
your ear.
8
1-800-221-2099 • www.HearingHelpExpress.com
Standard fit conversion
Full-length elbow joint tubing
Attach eartip
1. Push the flat end of the silicone eartip securely onto
the firm, plastic elbow joint at the end of the tubing.
Attention: Please make sure eartips are securely attached to the tubing and to
your Apollo hearing aid before using so they do not come off in your ear.
2
2. CUT OFF EXTRA
TUBING
Observe where the
tubing overlaps the
earhook & mark the
tubing leaving an 1⁄8
to ¼ inch overlap.
3
2. Attach tubing to
earhook
Insert the tip of the
earhook into the
tubing. If it is hard
to insert, warm the
tip of the tubing
with hot water.