Setup Routines - Knight ILCS Installation & Programming Manual

*** DISPENSER
2

SETUP ROUTINES

CHANGE DISPENSER ID# ?
PRESS: YES OR NO
N O Y E S
NEW DISPENSER ID# 00
THEN PRESS ENTER
CHANGE MAIN ACCESS CODE ?
PRESS: YES OR NO
N O Y E S
MAIN ACCESS CODE = 000
THEN PRESS ENTER
GO TO NEXT PAGE
Page 10 of 20
•
***
•
•
•
•
This menu selection allows you to change the dispenser ID
number. The dispenser ID number has two purposes:
•
It is printed in the upper-left corner of reports to identify which
dispenser the report came from. This can be helpful when more
than one dispenser is installed at the location.
•
When running ILCS WinReporter PC software (optional), the ID
number is used for "logging on" to the dispenser from the
computer. Several dispensers can be connected together in a
daisy chain format known as "multilinking". If using multilink, be
sure each dispenser has its own separate ID number before
attempting to logon.
Press YES to invoke the command, or press NO to move on to
the next menu selection.
Use the number buttons to enter a 2-digit ID number,
then press ENTER. Press the MENU
on to the next menu selection.
This menu selection allows you to change the main access code.
Press YES to invoke the command, or press NO to move on to
the next menu selection.
Use the number buttons to enter a 3-digit main access
code, then press ENTER. Press the MENU
move on to the next menu selection.
Change dispenser ID #
Change main access code
Set date and time
Set unit of measure
Set system operating time
button to move
button to
0901112 Rev: REL (08/03)