Toshiba 4818-T10 Service Manual page 9

4. Open the system box and detach the 50 pin LVSD cable (Section 5, step 1 to 5), and
then remove system box ,Remove stand base unit by release the 5 screws from
hinge plate then you can get Display Module off
5. Replace the new Display Module
6. Install Stand Base Unit
7. Install the System Board Box
8. When install the system board , please 50 pin LVDS connector direction and red dot
shall be follow below instruction and slide in tightly , otherwise , POS terminal may
not be get display powered on correctly
9