Cleaning; Troubleshooting; Technical Specifications - Evolite Xpress Beam 7x12 User Manual

o Cleaning
The cleaning of internal must be carried out periodically to optimize light output. Cleaning frequency depends
on the environment in which the fixture operates: damp, smoky or particularly dirty surrounding can cause
greater accumulation of dirt on the fixture's optics.
 Clean with soft cloth using normal glass cleaning fluid.
 Always dry the parts carefully.
 Clean the external optics at least every 20 days.
o Troubleshooting
Following are a few common problems that may occur during operation. Here are some suggestions for easy

troubleshooting:


The fixture does not work, no light
o
Check the connection of power and main fuse.
o
Measure the mains voltage on the main connector.

Not responding to DMX controller
o
DMX LED should be on. If not, check DMX connectors, cables to see if link properly.
o
If the DMX LED is on and no response to the channel, check the address settings and DMX
polarity.
o
If you have intermittent DMX signal problems, check the pins on connectors or on PCB of the
fixture or the previous one.
o
Try to use another DMX controller.
o
Check if the DMX cables run near or run alongside to high voltage cables that may cause
damage or interference to DMX interface circuit.

Some fixtures don't respond to the easy controller
o
You may have a break in the DMX cabling.
o
Check the LED for the response of the master/ slave mode signal.

No response to the sound
o
Make sure the fixture does not receive DMX signal.
o
Check microphone to see if it is good by tapping the microphone.


Technical Specifications

TECHNICIAL SPECIFICATIONS
Model
Voltage
Power consumption:
LED
Gross Weight
Dimensions
Xpress Beam 7x12 Manual Ver. 1.00
Xpress Beam 7x12
110V- 250V / 50-60Hz
100W
7 pcs X 12 W RGBW 4 in 1
5 Kg
270(H) x 150(l) x 210(L) mm
Page 19