Saeco Xelsis SM7686 Manual page 22

English
20
Problem
The machine is in DEMO
mode.
The 'coffee grounds
container full' icon
remains displayed.
The 'coffee grounds
container full' icon is
displayed even though
the container is not full.
I cannot remove the
brew group.
I cannot insert the brew
group.
The coffee is watery.
Cause
You pressed the standby
button for more than 8
seconds.
You emptied the coffee
grounds container while the
machine was switched off.
You placed back the coffee
grounds container too fast.
The machine did not reset the
counter the last time you
emptied the coffee grounds
container.
The brew group is not in the
correct position.
You have not removed the
coffee grounds container.
The brew group is not in the
correct position.
The brew group is dirty or
needs to be lubricated.
The grinder is set to a too
coarse setting.
The coffee settings have been
adjusted.
Solution
Switch the machine off and then on
again with the main switch on the back
of the machine.
Always empty the coffee grounds
container while the machine is switched
on. If you empty the coffee grounds
container when the machine is switched
off, the coffee cycle counter is not reset.
Do not place back the coffee grounds
container until the screen prompts you
to put it back.
Always wait approx. 5 seconds when
you place back the coffee grounds
container. In this way the coffee
grounds counter will be reset to zero.
Always empty the coffee grounds
container while the machine is switched
on. If you empty the coffee grounds
container when the machine is switched
off, the coffee grounds counter will not
be reset.
Reset the machine in the following way:
place back the drip tray and the coffee
grounds container. Then close the
service door and switch the machine off
and back on again. Try again to remove
the brew group.
Remove the coffee grounds container
before you remove the brew group.
Reset the machine in the following way:
place back the drip tray and the coffee
grounds container. Leave the brew
group out. Close the service door and
switch the machine on and off. Then put
the brew group in the correct position
and reinsert it into in the machine (see
'Reinserting the brew group').
Clean and lubricate the brew group.
Set the grinder to a finer (lower) setting.
Select your coffee drink and adjust the
settings to a stronger coffee.