Wirquin JOLLY TRONIC Instructions

Remove battery cassette cover with a screw
driver and place 4 x AA batteries into the
sensor battery cassette. Replace the battery
cassette cover and ensure that the screws are
in tight, so that the cover and batteries are
secure.
Place the threaded tube of the sensor
mechanism through the flush button hole of
the cistern. Screw on the white silicon ring to
the threaded tail protruding from the top of the
cistern lid. Once the silicon ring is secure,
place the black loose sensor plate back onto
the top of the sensor and screw on the blue
plastic sensor cover so that it is secure.
Tighten the black back nut under the cistern
lid up to the cistern lid to secure sensor.
Should the batteries fail, you can remove the
blue plastic sensor cover and black sensor
plate to expose the manual override. To
operate the manual override, just push the
black side of the button to flush.
Once the sensor and its parts are all securely
in place, attach the end of the flushing valve
cable clip to the button housing, next to the
battery cassette on the underside of the
sensor mechanism.
Tip! Ensure that the cable clip clicks onto the button housing to
ensure that it is secure.
Congratulations, you should now have a fully Wirquin no touch toilet
flush. However, should you encounter any problems, feel free to call
our helpdesk on: 01302 312235/02 or contact us via email, all our
details are shown below. We are open from
9am – 5pm, Monday to Friday (excluding bank holidays)
WIRQUIN FOR YOU!
Code No.
Issue date
Version
PMJOLLY03
19/2/14
1
FLUSHING VALVE AND KIT INSTRUCTIONS
(For flushing valve only follow section 2 and section 3)