Siemens SIMATIC CP 440 Manual page 170

Index
S
Saving the parameterization data, 3-2
SEND_440, 6-3
SEND_440 FB, 6-6
assignment in the data area, 6-8
block call, 6-7
error display, 6-6
parameters, 6-8
time sequence chart, 6-9
Sender line drivers, 7-4
Sending data
3964(R) procedure, 2-26
ASCII driver, 2-12
Sending with the 3964(R) procedure, 2-33
Sequence of steps, 3-2
Setup attempts, 5-16
SFC 41, 6-2
SFCERR, 6-8, 6-11, 6-15, 8-13
SFCERR variable, 8-13
Shield bus, 4-4
Simultaneously processed jobs, 6-5
Slave, 2-22
Slots, 4-2
Software components, 1-4
Special displays, 8-3
Special LEDs
RXD, 8-2
TXD, 8-2
Standard connecting cables, 1-3, 1-8
Standards, certificates and approvals, A-2
Start bit, 5-9, 5-17
Startup characteristics
CP 440 FBs, 6-23
programmable logic controller (CP 440),
6-23
STATUS on the FB, 6-5
STATUS output, 8-12
STATUS output of the FBs, 8-2
Index-4
STEP 7, 5-1
STOP, 7-2
Stop bits, 5-9, 5-17
Switchover time, 2-11
Symbolically addressed actual parameter, 6-22
T
Technical specifications, A-2
Time OBs, 6-2
Topologies, 2-22
Transmission attempts, 5-16
Transmission integrity, 2-8
with 3964, 2-9
with the ASCII driver, 2-9
Transmission pause, 5-8
Transmission rate
3964 procedure, 5-17
ASCII driver, 5-9
Transmission times, A-5
Two-wire mode, 5-6, 5-12
W
Weight, A-2
X
X27 (RS 422/485) interface, B-2
technical specifications, A-3
X27 interface
definition, 1-8
features, 1-8
XOFF code, 5-10
XON code, 5-10
XON/XOFF, 5-10
Point-to-point connection CP 440 Installation and Parameter Assignment
A5E00057742-02