Product Description
1.1
Applications of the CP 440
The CP 440 communication processor enables you to exchange data between
programmable controllers or computers by means of a point-to-point connection.
The CP 440 is designed to transfer short, fast frames.
The following are typically connected to it:
Scanners, barcode readers
Sensors
Weighing scales
Functionality of the CP 440
The CP 440 communication processor provides the following functionality:
An integrated MPI (Multipoint) X27 (RS422/485) interface
A maximum transmission length of 200 bytes
A transmission rate of up to 115.2 kbps, full-duplex
Integration of the most important transmission protocols in the module firmware
– ASCII driver
– 3964(R) procedure
Customization of the transmission protocols by means of parameter assignment
with the CP 440: Point-to-Point Communication, Parameter Assignment
parameterization interface.
Applications of the CP 440
The CP 440 communication processor allows point-to-point communication with
SIMATIC modules and with non-Siemens products. The SIMATIC modules that
can be connected are listed in Appendix C.
Functions Supported by the Interfaces
Table 1-1
Functions of the CP 440
3964(R) procedure
ASCII driver
XON/XOFF flow control
*
The RS 422 and RS 485 are distinguished by means of parameterization.
1-2
Function
Point-to-point connection CP 440 Installation and Parameter Assignment
CP 440
RS 422*
RS 485*
Yes
No
Yes
Yes
Yes
No
A5E00057742-02