Table of Contents
Advertisement
Fire Prevention Tips
If you must leave the kitchen when frying food, turn the
burner off or remove the pan from the burner until you
return.
In case of a grease fire:
NEVER attempt to move a pan of cooking grease that is
already on fire from the kitchen range.
NEVER attempt to extinguish a grease fire with water.
Instead, alert the other occupants and evacuate. Let the
fire suppression system installed in the hood extinguish
the range top fire. Wait at least 30 minutes after a
cooking fire has been extinguished before approaching
your range.
20
Fire Ready Hood
Service and Maintenance
Accessing Internal Components
NOTE
• All service on the fire suppression system should be
performed by authorized equipment distributor.
• Do not drop the unit into service position while
cooking on the range below.
WARNING
The hood is heavy. It is recommended to utilize
multiple people to drop the hood into the service
position; one person to support the hood while the
other disengages latches inside, as to prevent the
hood from causing injury.
ATTENTION
La hotte est pesante. Il est recommandé d'utiliser
plusieurs personnes pour abaisser la hotte en position
d'entretien, une personne supporte la hotte tandis que
l'autre dégage les loquets intérieurs pour empêcher la
hotte de blesser quelqu'un.
1. Pull down on
the two tabs
to release and
remove the
mesh filter from
the filter track.
2. Behind the mesh filter, in the left and right corner of
the plenum are two clamps holding the hood upright
in the normal operating position. Press the red button
on the bottom side of the clamp to unlock the clamp.
Then pull the large red handle down. Release the
clamps one at a time.
Before releasing the
second clamp, push up
on the bottom front lip
with one hand and use
the other to release the
second clamp.
3. With both clamps released, release the safety bolt
lever simply by pulling the black handle down. Keep
upward pressure on the bottom of the front part of
the hood while doing this. After releasing the safety
bolt, the hood front will want to drop. Slowly lower
the front of the hood until the safety cable is tight.
Safety Bolt Lever
Release
Tabs
Step 1
Step 2
Safety Cable
Advertisement
Table of Contents
