Table of Contents
Advertisement
Receiving
Product should arrive in a large carton. Upon receiving
the product, check to ensure all items are accounted
for by referencing the delivery receipt or packing list.
Inspect each crate or carton for shipping damage before
accepting delivery. Alert the carrier of any damage
detected. The customer will make notation of damage
(or shortage of items) on the delivery receipt and all
copies of the bill of lading which is countersigned by
the delivering carrier. If damaged, immediately contact
your Accurex Representative. Any physical damage to
the unit after acceptance is not the responsibility of the
manufacturer.
Unpacking
Verify that all required parts and the correct quantity of
each item have been received. If any items are missing,
report shortages to your local representative to arrange
for obtaining missing parts. Confirmation of shipment(s)
must be limited to only items on the bill of lading.
Parts Checklist
Hood with factory-installed Fire Suppression System
• Finished Top (optional)
• Ceiling Enclosures (optional)
Wall Mounting Bracket with J-Box
External Inline Fan (optional)
• One (1) 50 ft. Plug and Play Cable
Gas Disconnect (optional)
• 3/4 inch Gas Valve (plugs into gas shut off
assembly box)
• Gas Shut Off Assembly Box with 115VAC Range
Receptacle
• Two (2) 6 ft. Plug and Play Cables
Electrical Disconnect (optional)
• Electric Shut Off Assembly Box with 250VAC
Range Receptacle
• Two (2) 6 ft. Plug and Play Cables
Shipped Loose User Interface (optional)
• Recessed-Mount J Box
• One (1) 8
1
⁄
ft. Plug and Play Cable
2
Manual Pull Station (optional)
• One (1) 30 ft. Plug and Play Cable
Horn Strobe (optional)
• One (1) 8 ft. Plug and Play Cable
Wall Cap (optional)
K-Class Portable Fire Extinguisher (optional)
Fire Test Kit (optional)
2
Fire Ready Hood
Handling
Handle hood and accessories in such a manner as to
keep from scratching or chipping the coating. Damaged
finish may reduce ability of unit to resist corrosion.
Storage and Install Location Requirements
Units are protected against damage during shipment. If
the unit cannot be installed and operated immediately,
precautions need to be taken to prevent deterioration of
the unit during storage. The user assumes responsibility
of the unit and accessories while in storage. The
manufacturer will not be responsible for damage during
storage. The suggestions are provided solely as a
convenience to the user.
The ideal environment for the storage of units and
accessories is indoors, above grade, in a low humidity
atmosphere which is sealed to prevent the entry of
blowing dust, rain, or snow. Temperatures should be
evenly maintained between 32°F (0°C) and 120°F (49°C).
All accessories must be stored indoors in a clean, dry
location.
WARNING
The fire suppression system needs to be stored and
installed in locations where the temperature will not
fall below 32°F (0°C) and not exceed 120°F (49°C) for
proper operation.
AVERTISSEMENT
Le système extincteur d'incendie doit être entreposé
et installé dans des endroits où la température ne
descend pas sous 0°C (32°F) et ne dépasse pas
49°C (120°F) pour un bon fonctionnement.
Advertisement
Table of Contents
