Download Print this page

AudioCodes Mediant 1000B Quick Setup Manual page 3

Gateway & e-sbc
Hide thumbs Also See for Mediant 1000B:

Advertisement

2
CRMX
CRMX module, providing
The WAN / STATUS LED indicates the following:
3
SWX
LAN Extension (SWX) module, providing four additional Gigabit Ethernet LAN port
interfaces.
Note: The SWX module is a separate orderable item.
4
Power 1
Secondary Power Supply module, providing load sharing with and power
redundancy in case of failure in primary Power Supply module.
Note: The secondary Power Supply module is a separate orderable item.
5
Power 2
Primary Power Supply module with a status LED:
6
-
Fan Tray module and a schematic on its front panel showing the chassis' slot
numbers.
RS-232 serial interface port (flat connector).
Dry-contact relay connector for interfacing with a third-party, external alarm
system (separate orderable item).
Reset pinhole button for resetting the device or restoring it to factory defaults
(press and hold down the button for at least 12 seconds, but no more than 25
seconds).
Gigabit Ethernet LAN interface ports (RJ-45) for connecting IP phones,
computers, or switches. The ports support 1+1 Ethernet port redundancy
(active-standby), half- and full-duplex modes, auto-negotiation, and straight-
through or crossover cable detection. Each port has a status LED:
Green On
Ethernet link established.
Green Flashing
Data is being received or transmitted.
Off
No Ethernet link.
Red On
Reset button has been pressed.
Red Flashing
Note: When the device is ordered with dry-contact relay
interfaces, the LED label is STATUS; otherwise, the label
is WAN (despite no WAN interfaces).
Green On
Dry contact relay alarm: No Alarm (Dry Contact I Closed
and II Open).
Orange On
Dry contact relay alarm: Minor Alarm (Dry Contact I and
II Open).
Red On
Dry contact relay alarm:
Green On
AC power is received by device.
Off
No power.
3 |
P a g e
Under-voltage condition on CRMX module.
Booting up phase (U-boot) of the operating system
kernel has completed successfully.
Major Alarm (Dry Contact I and II Closed).
Critical Alarm (Dry Contact I Open and II Closed).

Advertisement

loading