LED INDICATIONS
- Constant blinking (~ 2Hz) – router is turning on.
- LED turned off – no 4G data connection, LED turned on – 4G data connection.
- Green and red blinking alternatively ever 500 ms: no SIM or bad PIN.
- Green, red and yellow blinking alternatively every 500 ms: connecting to GSM.
- Red blinking every 1 sec: connected 2G, but no data session established.
- Yellow blinking every 1 sec: connected 3G, no data session established.
- Green blinking every 1 sec: connected 4G, no data session established.
- Red lit and blinking rapidly while data is being transferred: connected 2G with
data session.
- Yellow lit and blinking rapidly while data is being transferred: connected 3G
with data session.
- Green lit and blinking rapidly while data is being transferred: connected 4G
with data session.
1. To enter the router's Web interface (WebUI), type
2. Use login information shown in image A when prompted for authentication.
3. After you log in, you will be prompted to change your password for security reasons. The new password must
contain at least 8 characters, including at least one uppercase letter, one lowercase letter, and one digit. This step is
mandatory, and you will not be able to interact with the router's WebUI before you change the password.
4. When you change the router's password, the
used to set up some of the router's main operating parameters.
5. Go to the
Status > Network
cellular performance try adjusting the antennas or changing the location of your device to achieve the best signal
conditions.
A.
http://192.168.1.1
Please enter username and password
admin
Username
admin01
Password
Login
LOGIN TO DEVICE
http://192.168.1.1
Configuration Wizard
page and pay attention to the
B.
into the URL field of your Internet browser.
will start. The
Signal Strength
indication (image B). To maximize the
Mobile Information
Mobile
Data connection state
IMEI
IMSI
Sim card state
Signal strength
SIGNAL STRENGTH LEDS
Configuration Wizard
is a tool
Connected
123456789012345
123456789012345
Ready
-79 dBm
Need help?
Do you have a question about the RUT950 and is the answer not in the manual?