Advertisement
Basic Installation
1.
Wire the readers to the AW2.
2.
Wire the desired inputs to the
AW2.
Wire the locks to the AW2 relay
3.
terminals.
4.
Place the AW2 label in the correct
location on the back page of the
ACW2-XN quick guide. This will be
used during door setup.
HID Access Manager
Required Settings
1.
Go to the 'Doors' menu and click 'Device Discovery' to detect the new
AW2 module
2.
Add/Configure the new doors and readers
Specifications
Wiegand Module (AW2)
Relay Rating
Recommended
Cable Specifications
Note:
It is best practice to use an additional fused power supply for the locks
Trademarks
HID GLOBAL, HID, the HID Brick logo, the Chain Design, ICLASS, ICLASS SE, SEOS, and OMNIKEY are trademarks
or registered trademarks of HID Global, ASSA ABLOY AB, or its affiliate(s) in the US and other countries and may
not be used without permission. All other trademarks, service marks, and product or service names are trademarks
or registered trademarks of their respective owners.
Relay 1
Inputs 1
Reader 1
[10A, 28VDC] [5A, 220VAC] [12A, 120VAC]
Input & Wiegand: >=22AWG, Max 150m
Relay: >=18AWG, Max 150M
Relay 2
Inputs 2
Reader 2
AW2
Advertisement
