Advertisement
materials. Do not use for non-metal materials.
The product is intended to be used only by adult operators who have
read the instruction manual and understand the risks and hazards.
The product is intended to be fixed at the base to a solid bench top.
If the base is not securely fixed the whole machine may move during
cutting operations, which increases the possibility of serious personal
injury.
The product is to be used in dry conditions, with excellent ambient
lighting and adequate ventilation.
The product is intended for consumer use and should only be used as
described above and is not intended for any other purpose.
MAINTENANCE
Do not make any adjustments while the motor is in motion.
Always make sure the machine's plug has been removed from the
mains power source before changing brushes, lubricating or when
doing any works or maintenance on the machine.
After each use, check your machine for damage or broken parts
and keep it in top working condition by repairing or replacing parts
immediately. Clean out accumulated dust.
To assure safety and reliability, all repairs with the exception of
externally accessible brushes should be performed by an authorised
service centre.
If the power supply cord is damaged, it must be replaced only by the
manufacturer or by an authorized service center to avoid risk. Contact
authorized service center.
The ventilation slots of the machine must be kept clear at all times.
Use only AEG accessories and AEG spare parts. Should components
need to be replaced which have not been described, please contact
one of our AEG service agents (see our list of guarantee/service
addresses).
If needed, an exploded view of the tool can be ordered. Please state
the Article No. as well as the machine type printed on the label and
order the drawing at your local service agents or directly at:
Techtronic Industries Australia Pty Ltd
PO Box 1065
Mount Waverley VIC 3149
Tel. no. 1300 234 797
Australia
Techtronic Industries N.Z. Limited
PO Box 12-806
Penrose AUCKLAND 1642
Tel. no. 0800 234 797
New Zealand
24
SYMBOLS
Safety alert
Regulatory Compliance Mark (RCM). Product meets
applicable regulatory requirements.
Please read the instructions carefully before starting
the machine.
Class II tool, double insulation
Wear ear protection
Wear eye protection.
Not for wet grinding or cutting
Do not use chipped, cracked or defective grinding
wheel
Wear safety gloves
Wear dust mask.
Do not expose to rain or use in damp locations.
Do not dispose of electric tools together with
household waste material. Electric tools and
electronic equipment that have reached the end of
their life must be collected separately and returned
to an environmentally compatible recycling facility.
24
Advertisement
