IBM WebPoint Installation Card page 5

Adding Additional Computers
If you have other computers on your network, you are now ready to connect them. Each computer you want to connect to Web Point
must have both a Network Interface Card installed and TCP/IP installed. Follow these steps to set up additional computers:
Connect each computer to Web Point using Ethernet (10BaseT) cables. (If you have a Home Network Connection Center installed,
1
connect Ethernet cables to a computer tap point mounted in the wall.)
Turn on the computer.
2
Insert the EasyStart CD in the CD-ROM drive and run EasyStart . Follow steps 1 to 5 in "Setting Up a New Network."
3
Restart the computer if requested by EasyStart .
4
5 The "DHCP Verifier" screen will open. Click Browse Internet.
The computer should connect to the Internet through Web Point and the new network you just created.
Notes: If you have trouble connecting to the Internet, see "Troubleshooting" in the Reference Manual.
You do not need to reconfigure Web Point when setting up additional computers on the network.