Samsung VRR P10 Product Manual page 7

VRR P10 products can not be used in the lampblack-abundant environment,

because the use of such environment will cause a layer of greasy residue on the
surface of the module, which is difficult to remove.
VRR P10 products can not be placed in an environment with no ventilation and

near the high heat source (such as laser irradiation environment, beside the
stove).
The voltage and power of the power supply equipment of the VRR P10 must

meet the requirements.
When the VRR P10 products are not used for a long time, please cut off the

power supply to avoid a safety accident.
When installing or disassembling the VRR P10 products, pay attention to the

corners of the cabinet, do not be impacted, remove or install the protective angle
of the cabinet in time, and place the anti-static carpet on the ground of the cabinet.
Anti-damage module or lamp surface.
The power cables and signal cables between the cabinets are not allowed to be

hang with anything.
VRR P10 modules should not be used near any device other than CE and UL /

ETL certified.
The VRR P10 is an outdoor product. Do not install or use it in an outdoor

environment. Keep the product in a dry environment and avoid direct sunlight.
When reconnecting the power and signal cables, ensure that the cables are

connected according to the installation manual to prevent damage to the cables
or other components.
The air suction tool is used to disassemble the module. The method of use must

conform to the specifications. Refer to Appendix D "How to Use the Air Suction
Tool" to avoid damage to the module due to improper operation.
When using the rolling mask tool, the action should be light to avoid damage to

the module.
VRR P10 products are limited to vertical installation: hanging and stacking, 12

cabinets max to hang and 12 cabinets max to stack.
For small-pitch products, it is easy to be damaged and easily damaged. In the

process of using, you need to wear anti-static gloves and handle them with care.
7 / 50