Table of Contents
Advertisement
3 NAMES AND FUNCTIONS OF PARTS
This section describes the names and functions of the parts of the S5U1C6S3N2E2.
3.1 Basic Functions
The S5U1C6S3N2E2 has the following basic functions:
Program execution (Run function)
Install the EPROM containing the application program and execute the program.
Interface with ICE
The S5U1C6S3N2E2 can interface with the ICE so that a higher level debugging environment may be
established.
Setting hardware options by installing function option and segment option ROMs
Hardware options, i.e., I/O ports and LCD segments, can be specified by writing option data for the
function option created by the function option generator and the segment option created by the
segment option generator into EPROM, and installing it to the S5U1C6S3N2E2.
3.2 Functions of Parts
3.2.1 Front panel
EVA6S32R
E0C6S32/6233/6009 EVALUATION BOARD
EPSON
Fig. 3.2.1.1 Front panel
3.2.2 Rear panel
+5V GND
O I
DC IN
POWER SW
Fig. 3.2.2.1 Rear panel
Note: Be sure to disconnect external power source
before connection with the ICE, because power is
supplied from the ICE when the S5U1C6S3N2E2
is connected to the ICE.
S5U1C6S3N2E2 MANUAL
(EVALUATION BOARD FOR S1C60N09/6S3N2/62N33)
• • • • • • • • • • • • • • • • • • • • • • • • • • • •
• • • • • • • • • • • • • • • • • • • • • • • • • • • •
• • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •
• • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •
Position of pin 1
• • • • • • • • • • • • • • • • • • • • • • • • • • • •
• • • • • • • • • • • • • • • • • • • • • • • • • • • •
• • • • • • • • • • • • • • • • • • • • • • • • • • • •
• • • • • • • • • • • • • • • • • • • • • • • • • • • •
Position of pin 1
EPSON
3 NAMES AND FUNCTIONS OF PARTS
Connectors
• I/O #0
Connector for the I/O cable. The I/O cable
is used to connect the S5U1C6S3N2E2 to the
target system.
• LCD #0
Connector for the LCD cable. The LCD cable
is used to connect the S5U1C6S3N2E2 to the
target system.
Switch
• POWER SW
This is a switch to turn on or off the external
F1
power supply to the S5U1C6S3N2E2. (Turn
F5
off the POWER switch when the ICE is
connected.)
Connectors
• DC IN 5 V
This is a connector with external power
supply source. The external power supply
should be in direct current of 5 V for 3 A or
more.
• F1, F5
Connectors for the ICE interface cable.
3
Advertisement
Table of Contents
