Asco 8003P Series Installation & Maintenance Instructions

Installation & Maintenance Instructions
SERVICE NOTICE
r
S
S
S
S
S
See separate instructions for basic valve.
DESCRIPTION
I
ASCO Solenoid Valves with P" in the middle of the catalog
number are not suitable for steam service.
See Temperature Limitations section for solenoid
identification and see nameplate for service
OPERATION
Voltage Ranges:
50 Hanover Road, Florham Park, New Jersey 07932 www.ascovalve.com
GENERAL PURPOSE-WATERTIGHT SOLENOIDS
r
r
r
_
Voltage Range
100-240V/50 or 60Hz/DC (1)
24-99V/50 or 60Hz/DC (1)
t
12-24/DC only (2)
:
Note:
When the solenoid is de-energized, the initial return force
for the core, whether developed by spring, pressure, or
weight, must exert a minimum force to overcome residual
magnetism created by the solenoid. Minimum return force
is 0.69lbf [3.06 N].
IMPORTANT: Initial return force for the disc or disc holder
assembly, whether developed by spring, pressure, or weight,
must exert a minimum force to overcome residual
magnetism created by the solenoid. Minimum return force
is 1.30 lbf [5.78 N].
WARNING:
accessibility of live parts. To prevent the possibility
of death, serious injury or property damage, install
the open - frame solenoid in an enclosure.
WARNING: Leakage current from solid state
controls can cause improper operation. Check for
current in the OFF-STATE from the switch with the
solenoid disconnected. Leakage current for solid
state outputs greater then 3 mA must use additional
external loads. Do not use supervisory circuits with
this solenoid.
I&M No.V7501R5
:
Minimum Voltage Maximum Voltage
85
20.4
10.4
IMPORTANT:
INSTALLATION
Electrical hazard from the
Page 1 of 4
All Rights Reserved.
E185217
SERIES
8003P
8007P
8202P
264
109
26.4