Connections For A Digital Non-Linear Editing System - Sony DVCAM DSR-60P Operating Instructions Manual

Connections for a Digital Non-Linear Editing
System
This unit can be connected to an ES-7 EditStation to
configure a digital non-linear editing system.
If you use the QSDI interface, you can transfer video,
audio, time code, and other compressed data from this
unit to the ES-7.
The unit supports ClipLink functions, enabling index
pictures recorded on tape and ClipLink log data stored
in cassette memory to be transferred to the ES-7 in an
instant.
REF. VIDEO IN
ANALOG I/O
REF.VIDEO VIDEO OUT
COMPONENT VIDEO
TIME CODE OUT
AC IN
S VIDEO OUT
MONITOR
AUDIO
MONITOR
AUDIO
3
Audio input
Video monitor
Settings on the DSR-60/60P
Switch
REMOTE/LOCAL
REF. VIDEO IN 75 Ω termination
QSDI OUTPUT
QSDI SDI OUTPUT
AUDIO OUT
TBC REMOTE REMOTE
VIDEO OUT 2
DSR-60/60P
(SUPER)
1
Composite video input
Setting
REMOTE
ON
For a general description of ClipLink functions, refer to
"ClipLink™ Guide" supplied with the unit.
The following figure shows a connection diagram for
non-linear editing system in which this unit serves as
the player.
For connections of the ES-7 and its peripheral devices such
as the ESBK-7011 Control Panel, the ESBK-7045 Disk Unit,
etc., refer to your ES-7 Operating Instructions.
1
B B OUT(1/2/3/4)
1
QSDI INPUT
2
REMOTE PLAYER
1 75 Ω coaxial cable (not supplied)
2 9-pin remote control cable (one cable
is supplied with the DSR-60/60P)
3 Cable with RCA phono plugs
(not supplied)
ES-7 EditStation
Chapter 5 Connections and Settings
41