Sony DVCAM DSR-60P Operating Instructions Manual page 11

3 Menu control panel
The menu control panel is located on the inside of the
door at the lower front of the unit. Press on the top of
the door to open it.
1 SYNC PHASE control
2 SC PHASE control
SYNC PHASE SC PHASE
MONITOR SELECT
CH- CH- CH-
1/2 3/4 1/3
MIX
7 MONITOR SELECT switches
1 SYNC (synchronization) PHASE control
Turn this control to accurately adjust the
synchronization phase of the output video signal of the
unit with respect to the reference video signal. Use a
cross-point (Phillips) screwdriver to turn it.
2 SC (subcarrier) PHASE control
Turn this control to accurately adjust the subcarrier
phase of the composite video output signal of the unit
with respect to the reference video signal. Use a cross-
point (Phillips) screwdriver to turn it.
3 MENU button
Press this button to display the menu on the monitor
screen and the time counter display. Press it again to
return from the menu display to the usual display.
4 Arrow (˘, ≥, ¿ [A], [B]÷) buttons
Use these buttons to move around the menu items and
select or check the top and end points of repeat
playback.
3 MENU button
4 Arrow buttons
MENU
A B
CH-
2/4
MARK
To expose the menu control panel
Press on the
top of the door.
5 RESET (NO) button
RESET(NO)
SET(YES)
6 SET (YES) [MARK] button
5 RESET (NO) button
Press this button to:
• reset menu settings,
• reset the time data shown in the time counter display
to zero, or
• send a negative response to the unit's prompts.
6 SET (YES) [MARK] button
Press this button to:
• save new settings, such as selected menu items, to the
unit's memory,
• send a positive response to the unit's prompts, or
• set (save in memory) the selected top and end points
of repeat playback.
PUSH OPEN
Chapter 1 Overview
11