Menu Contents - Sony DVCAM DSR-60P Operating Instructions Manual

Menu Contents

The purpose and settings of the setup menu items are
described below.
Indications of menu Items and settings
• In the table below entitled "Menu Contents", the
indication of each menu item or setting on the
monitor screen is shown first, then the indication of
the same item or setting on the time counter display
of this unit is shown in square brackets ([ ]).
(Examples)
Indication in monitor
screen
OPERATIONAL FUNCTION
REPEAT TOP
∗TAPE TOP
REPEAT FUNCTION [REPEAT FUNC]: Repeat playback
settings
REPEAT MODE [> REPEAT MD]: Select whether or not to
put the unit into repeat playback mode.
REPEAT TOP [> REPEAT TOP]: Determine whether the
repeat top point is the top of tape or point A.
REPEAT END [> REPEAT END]: Determine whether the
repeat end point is the end of the recorded portion, the end
of tape or point B.
A PRESET [> A preset]: Specify a time code value to be used
as the setting of point A.
B PRESET [> B preset]: Specify a time code value to be used
as the setting of point B.
OPERATIONAL FUNCTION [Operational]: Operation
settings
LOCAL ENABLE [> Local ENA]: Select which of the tape
transport control buttons (EJECT, REW, PLAY, F FWD,
STOP) operate when the REMOTE/LOCAL switch is set to
REMOTE.
MAX SRCH SPEED [> Max SRCH]: Set the maximum value
for search mode.
AUTO REW [> AUTO REW]: Determine whether or not to
rewind automatically when playback reaches the end of a
tape.
32
Chapter 4 Menu Settings
Indication in time
counter display
[Operational]
[>> REPEAT TOP]
[>> Tape top]
Menu contents
• Settings that have an asterisk in front of them (such
as ∗TAPE TOP) are factory default settings.
• On the time counter display, one to three ">" symbols
may precede item or setting indications depending on
the current menu level. Larger numbers of ">"
symbols indicate lower menu levels.
Description of settings
∗OFF [>> OFF]: Do not put the unit into repeat playback
mode.
ON [>> ON]: Put the unit into repeat playback mode.
∗TAPE TOP [>> Tape top]: The repeat top point is the top of
tape.
A POINT [>> A point]: The repeat top point is point A as set
by the user.
∗VIDEO END [VD end]: The repeat end point is the end of the
recorded portion.
TAPE END [>> Tape end]: The repeat end point is the end of
tape.
B POINT [>> B point]: The repeat end point is point B as set
by the user.
For details see page 20.
For details see page 20.
Description of settings
ALL DISABLE [>> All DIS]: All of the tape transport control
buttons are disabled.
∗STOP & EJECT [>> STOP & E]: Only the STOP and EJECT
buttons are enabled.
ALL ENABLE [>> All ENA]: All of the tape transport control
buttons are enabled, and settings such as preroll time
change or time data display selection are effective.
∗× 32 [>> × 32]: Restrict the search speed to the maximum
32 times normal for which the picture can be seen on the
monitor. Use this setting when using search mode for
cueing.
× 85 [>> × 85]: Allow searching at up to the maximum tape
transport speed of 85 times normal. The picture cannot be
seen on the monitor at this speed.
∗ENABLE [>> ENABLE]: Rewind automatically.
DISABLE [>> DISABLE]: Do not rewind automatically.
(Continued)