Maintenance - Stanley SXEW174001 Manual

NOZZLES
Your pressure washer is supplied with these nozzles;
ADJUSTABLE NOZZLE (PIC. 9)
This nozzle can be adjusted while in use there is no need to stop
the water flow.
Being an adjustable nozzle, there are many different
positions which will give a variety of different spray widths
and water pressure.
WARNING: Never point or spray water at people or animals,
injury will occur.
WARNING: When adjusting the nozzle be careful of your hand
as the injury may occur if the water spray touches your hand.
LOW PRESSURE AND WIDE SPRAY
While holding the gun twist the nozzle to the left.
HIGH PRESSURE AND NARROW SPRAY
While holding the gun twist the nozzle to the right.
TURBO NOZZLE
This nozzle has a circular spray pattern which also oscillates
slightly. This is ideally used for pavers or concrete.
TO CHANGE NOZZLES
1. Ensure the pressure cleaner is turned OFF.
2. Push the red button on the lance in.
3. Remove the nozzle.
4. Select the next nozzle.
5. Push the red button on the lance in.
6. Push the nozzle in and release the red button.
7. Turn pressure washer back on and continue cleaning.
PIC. 9
MAINTENANCE INFORMATION
It is recommended after every use or when required that
following items are cleaned.
NOZZLE
When the nozzle is clogged, it will cause the pump to build
pressure and may cause unit to surge, you can clean the nozzle
inserting needle into the tip to rid of the deposits.
For the adjustable nozzle, you can also lubricate the nozzle
collar (high pressure to low pressure ) by using non-water
soluble grease regularly.
INLET FILTER
The inlet filter may become blocked.
To check and clean:
1. Turn unit OFF and disconnect from mains power.
2. Turn water OFF.
3. Bleed off excess water and disconnect from mains water.
4. Unscrew and remove hose connector.
5. Remove white filter and check and clean.
6. Once clean replace white filter and re-fit the hose
connector.
7. Turn Water on and bleed pressure washer.
8. Turn pressure washer on and resume cleaning.
CLEANING
NEVER use this pressure cleaner to clean itself. Damage caused
by cleaning the pressure washer with its own gun will not be
covered under warranty. Ensure pressure washer is cool before
cleaning, about 1 hour after use.
• Wipe down all surfaces with a soft clean cloth.
• Rinse all nozzles, detergent bottle in a bucket of clean water.
• Allow to dry before storing.
STORAGE
NOTE: When storing the pressure washer, parts, and
accessories always store in a secure area with a temperature
above 0° C.
LONG-TERM STORAGE
FOLLOW ALL OF THE NORMAL SHUT-DOWN PROCEDURES
HOWEVER ADD THESE FOLLOWING STEPS....
• After disconnecting the water supply, and before
disconnecting the high-pressure hose, turn the pressure
cleaner on for 2-3 seconds, until any remaining water in the
pump exits. TURN UNIT OFF IMMEDIATELY.
CONTINUED USE OF THE PRESSURE CLEANER WITHOUT
WATER SUPPLY ATTACHED WILL CAUSE SEVERE DAMAGE TO
THE UNIT!
14