INTRODUCTION Dear Customer, HOW TO CLAIM UNDER THIS WARRANTY • Call customer service. Thank you for purchasing this pressure washer which has passed through our extensive quality assurance processes. • Ensure you have the following: Original purchase receipt, Every care has been taken to ensure that it reaches you in Model of pressure washer, Serial number of pressure perfect condition.
COMPLETE WARRANTY STATEMENT – PRESSURE WASHER As soon as you have purchased the pressure washer, we Damage caused by third party accessories is not covered under recommend that you check to make sure it is intact and that you this warranty. read the operating instructions carefully before using it.
GENERAL SAFETY INSTRUCTIONS SELECT A PRESSURE WASHER WITH A ASSEMBLY SUFFICIENT RATING This pressure washer MUST be fully assembled by you prior to use. Failure to do so will result in the warranty being VOID. Select the right pressure washer for the job. Do not use a Failure to fully assemble this pressure washer may also result in pressure washer to do a job for which it was not designed.
Page 6
GENERAL SAFETY INSTRUCTIONS MAINTAIN YOUR PRESSURE WASHER WITH CARE CLEANING YOUR PRESSURE WASHER When not using your pressure washer ensure the ON/OFF Always stop your pressure washer before you commence switch is ‘OFF’. Never leave the ON/OFF switch ‘ON’ as this can cleaning.
PERSONAL SAFETY INSTRUCTIONS CLOTHING RESPIRATORY PROTECTION Do not wear loose clothing, jewellery or anything that could get When cleaning dirt, concrete, man-made fibres, especially MDF caught in moving machinery. (Medium Density Fibre board), the resin used in these materials can be hazardous to your health. Use an approved face mask HAIR with replaceable filter.
SPECIFIC SAFETY INSTRUCTIONS Warning! Do not use the pressure washer in areas where • Never point gun/lance at people or animals. there is a risk of explosion or fire from combustible materials. • Never hose or wet people or animals. The sparks possibly caused when using this pressure washer •...
PIC. 1 1. Power cord and plug (not shown) 2. On / Off Switch 3. Hose and power cord hook 4. Handle 5. Gun with trigger 6. Nozzle 7. Gun and accessories hook 8. Lance 9. Wheel 10. High pressure hose connection...
UNPACKING & ASSEMBLY PIC. 2 UNPACKING Note: Carefully unpack your pressure washer. Dispose of all packing material in an environmentally responsible manner. Open carton, gently lift the pressure washer clear of the carton and packaging, Remove from plastic bag. Note: Plastic bags can be a danger to young children, dispose of immediately.
Page 11
PRESSURE HOSE TO PUMP CONNECTION (PIC. 5) PIC. 5 To connect hose; 1. Push lever in towards the left and push the hose fitting in, release the lever. Hose fitting should be locked in place. PRESSURE HOSE TO GUN CONNECTION (PIC. 6) To connect hose;...
OPERATING INSTRUCTIONS PIC. 8 WARNING: THIS UNIT IS INTENDED TO BE USED WITH COLD WATER ONLY! DO NOT USE HOT WATER IN THIS PRESSURE CLEANER! STARTING AND STOPPING YOUR PRESSURE CLEANER Never switch your pressure cleaner ON unless the water has been turned on and connected to the pressure cleaner first.
Page 13
TO STOP USING PIC. 9 1. Release the trigger and switch the unit to the OFF position. 2. Turn the main water tap OFF. 3. Squeeze the trigger to release the water pressure. 4. Engage the safety gun lock. 5. Disconnect the water hose and pack up your pressure washer.
MAINTENANCE INFORMATION It is recommended after every use or when required that STORAGE following items are cleaned. NOTE: When storing the pressure washer, parts, and accessories always store in a secure area with a temperature NOZZLE above 0° C. When the nozzle is clogged, it will cause the pump to build pressure and may cause unit to surge, you can clean the nozzle LONG-TERM STORAGE inserting needle into the tip to rid of the deposits.
CLEANING TIPS RECOMMENDATIONS Always clean from top to bottom and from left to right. For stubborn dirt/stains you can use the turbo nozzle. Be careful as If painted surfaces are peeling or chipping, use extreme the turbo nozzle may damage timber or some surfaces if held caution as pressure washer may remove the loose paint too close or too long on the area.
84 EW1450HH STANLEY®, The STANLEY Logo, The Notched Rectangle and the Yellow and Black Diagonal Package Design are all trademarks of the Stanley Black & Decker, Inc or an affiliate thereof and are used under license. Product manufactured and distributed by Smart Marketing Group Pty Ltd. Manufactured in China.