Manual Layout; Appendix; Symbols Used - Automation Direct T1K-MODBUS-M User Manual

Manual Layout

The contents of this user manual are as follows:
Chapter
1
Introduction
T1K–MODBUS
2
Specifications
MODBUS RTU Functions
3
and Addressing Modes
Using T1K–MODBUS
4
Setup Tool
Appendices Additional reference information for the T1K–MODBUS is available in the following
appendices.

Appendix

I/O Module
A
Hot Swap
Analog Output Module
B
Configuration

Symbols Used

The "note pad" icon in the left–hand margin indicates a special note.
The "exclamation mark" icon in the left-hand margin indicates a warning or caution.
These are very important because the information may help you prevent serious
personal injury or equipment damage.
The "light bulb" icon in the left-hand margin indicates a tip or shortcut.
Title
introduces MODBUS and describes both the Terminator
I/O System and the T1K–MODBUS Base Controller
provides module specifications, dip switch settings, port
pin–outs and wiring information.
provides MODBUS RTU functions supported and use
with DirectLogic PLCs, or MODBUS 584/984 modes.
explains how to configure the MODBUS port using the
Setup Tool.
Title
explains the T1K–MODBUS I/O module Hot Swap feature
and the Enable/Disable Outputs switch.
uses a memory map to explain how to configure an analog
output module.
Introduction
What's covered
What's covered
1–3