Erx Quick Start Guide - Interfacing With Nomad; Interfacing The Erx With A Nomad - Zaxcom ERX2TCD User Manual

Zaxcom ERX3TCD

ERX Quick Start Guide - Interfacing with Nomad

Interfacing the ERX with a Nomad

1. In the main menu of Nomad select ZaxNet Setup
2. Scroll down and select Input Configure. Make sure that the input configure is set to 8 or higher. Press the
back button and return to the ZaxNet Setup Menu.
3. Power cycle your Nomad
4. Return to the ZaxNet setup menu scroll up and select IFB Mode. Make sure that it is set to TX or TX+RX
5. Scroll down and select the transmit frequency.
6. Scroll down to choose a group code.
7. Power on the ERX while holding the menu button to access the extended menu.
8. Advance to the time code frame-rate menu and set the frame rate to the same frame rate that Nomad is set
to or turn on the auto-frame rate option.
9. Press the menu key to enter the IFB frequency
transmit frequency that is set in Nomad or turn auto frequency select. If the ERX is receiving a good signal,
there will be two vertical signal strength bars on the right side of the screen.
10. Advance to the time code output enable menu. If using the ERX as an IFB for a personal monitor leave the
time code output set to OFF. If the ERX is being used to output time code select "OUT LEFT TIP" or "OUT
RIGHT" or "BOTH".
11. If the camera has trouble seeing time code, proceeded to the TC output level menu and adjust the time code
voltage level until the camera recognizes the time code.
12. In the Nomad BUS MENU advance to the TAPE / IFB out and route the audio to the ERX. Any
combination of card tracks, outputs or returns can be selected.
menu. Set the receive frequency the same as the
select
Page 14
Interfacing with a Nomad