Environmental Compatibility, Disposal; Safety And Emc Optimization; Notes On Safety; Device-Specific Regulations - Siemens QMX3.P37 Technical Principles

General notes
Environmental
declaration
Please comply
with these notes
General
regulations
Safety
KNX bus supply
Warning,
maintenance
10 / 40
Siemens
Building Technologies
2.6

Environmental compatibility, disposal

This device was developed and manufactured with environmentally compatible
materials and procedures complying with all relevant environmental standards.
Note the following to dispose of the product following its useful life or in case of
replacement:
• Do not dispose of the device as part of standard household garbage, but as
special waste from plastic and steel, ferrite-magnet components.
This applies in particular to the PCB.
• For this reason, dispose of the components compatible with current
environmental, recycling, and disposal technologies.
Observe all local, applicable laws.
• The aim is to reuse as much of the basic materials as possible at the lowest
possible environmental impact. To this end, note any material and disposal
notes in individual components.
The product environmental declaration CM2E1602 contains data on
environmentally compatible product design and assessments (RoHS compliance,
materials composition, packaging, environmental benefit, disposal)
3

Safety and EMC optimization

3.1

Notes on safety

This section explains general and system-specific regulations for mains and
operating voltages. It includes important information for your safety and the safety
of the entire plant.
Please comply with the following general regulations during engineering and
execution:
• Electrical and mains power ordinances for the given country.
• Other applicable, national regulations.
• Building installation regulations for the given country.
• Regulations of the utility company.
• Diagrams, cable lists, dispositions, specifications, and orders by the customer or
authorized engineering office.
• Third-party regulations, e.g. by the general contractor or building owner.
The electrical safety for building automation and control systems by Siemens is
essentially based on safely separating low voltage from mains voltage.
3.2

Device-specific regulations

Note permissible line lengths and topologies when planning and installing
controllers and field devices featuring KNX bus connection. Make sure the bus
supply complies with the KNX standard.
Do not open the device.
The device is maintenance free. Only the manufacturer can maintain the device.
Wall-mounted sensors and room operator units for KNX S-Mode and KNX LTE-Mode CM2N1602en_01
Safety and EMC optimization 2013-07-04