Replacing Belt Wraps; Mcdonald's - A.J.Antunes VCT-250 Manual

Rapid toasteR VCt-250

Replacing belt Wraps

Note: follow steps 1-3, page 12 if necessary.
. Locate the hinge Flap on the Belt Wrap, if the
hinge Flap is not visible; plug in the power
cord and turn the unit on, press down on both
Conveyor Safety Interlock Switches (Figure 0)
and wait until the flap is exposed and centered.
Turn the unit off and unplug the power cord, lift
flap, remove the hinge Pin, and carefully remove
the Belt Wrap from the unit (Figure 4). Discard
this belt. Repeat this process for the rear (Crown)
side.
2. Install the new Belt Wraps with the hinge Flap
hanging down and the wavy lines facing out, as
shown in Figure 6.
CaUtioN
be sure belt Wrap ends are aligned as shown in
figure 15 or damage to the belt Wrap will occur.
Note: the belt Wraps must be installed inside the
yellow support Rods. the flap, should be installed
facing the outside of the toaster and should be in
the down position (figures 14 & 16).
CaUtioN
be sure the belt Wrap is positioned iNside the
upper and lower yellow support Rods or damage
to the belt Wraps will occur.
3. Close the front and rear Conveyor Covers by lift-
ing the covers and gently pushing upward and
into the toaster until the covers latch onto the yel-
low Support Rods.
Note: Make sure both Conveyor safety interlock
switches are activated when the covers are
installed (figure 11) or the conveyors will not
rotate.
MaiNteNaNCe (continued)
4
Upper Yellow Support Rod
Lower Yellow Support
Belt Wrap Pin
Rod
figure 14. Replacing belt Wrap
INCORRECT
figure 15. aligning belt Wrap teeth
Belt Wrap
Rotation
figure 16. Correct belt Wrap installation
Belt Rotation
CORRECT
Direction of Travel
Horizontal Rib
Installed to the INSIDE
P/N 00837 Rev. L 03/07

McDonald's