Figure 2-2 Sample Sensor Label - Siemens SITRANS F Series Quick Start Manual

Installing/mounting
2.3 Sensor Label Information
Hot Surface
External spool temperature can exceed 93°C (200°F). If this surface is contacted, the
potential for injury exists.
To reduce the risk of injury allow the surface to cool before touching.
Sensor Failure
Exceeding rated pressure identified as MAOP may cause Sensor failure and the potential
for injury.
Check all pressure ratings before installing sensors.
Figure 2-2
16
WARNING
WARNING
TM
TransLoc
Hazardous information here.
May vary depending on model
purchased.
Install per Siemens Dwg. A5E02716838A
Sample Sensor Label
SYSTEM P/N
S/N
SENSOR P/N
S/N
TRANSMITTER P/N
S/N
TM
WideBeam TRANSDUCER P/N
DOM
FUT1010 IP65 NEMA 4X & IP66 NEMA 7 Liquid Quick Start
Siemens Industry, Inc
Industry Automation
Spring House, PA
METER SIZE / CL
I.D .
WEIGHT
MAT BODY/FLANGE
BODY DESIGN CODE
FLANGE DESIGN CODE
Qmin/Qmax
Min OP / MAOP
OP TEMP
STORAGE TEMP
DOT
TEST PRESSURE (BAR)
IP65 / NEMA 4X
A5E02639002 Rev.04
Operating Instructions, 1/2013, A5E02639182-AC