Acp Program Registers; Register 01 - Mode Flags; Register 02 – Cadence On Time; Register 03 - Cadence Off Time - Multi-Link Polnet ACP-5 Manual

ACP PROGRAM REGISTERS

The ACP has been designed to perform several operations, which are integral to the proper function of your total
communications system. The operations are controlled by programmable information, which is stored in files called "registers".
Each register contains enough memory to hold factory preset default values and "custom" values that allow the ACP to operate
to your specifications. The following is a short description of each register function, program capacity and factory preset default
values.

Register 01 - Mode Flags

This register controls 8 features or operating modes performed by the ACP. Each "flag" or feature can be turned on/off and is
programmed as a string of bit information. Zero (0) denotes "off" and one (1) denotes "on". The Mode Flags are factory preset to
the following:
The Mode Flags are factory preset to the following:
Flag 1 (Bit 7) Caller ID delay
Flag 2 (Bit 6) Fax Tone Detect to Device 2
Flag 3 (Bit 5) Night Watch Mode
Flag 4 (Bit 4) Additional Detect Time
Flag 5 (Bit 3) Protected Hook Flash
Flag 6 (Bit 2) Busy Signal
Flag 7 (Bit 1) Enable Multi-Port Polling
Flag 8 (Bit 0) Night Watch Mode to Device 3
The operation modes (Flags) can be programmed to meet the specifications that your system requires to function optimally.
REGISTER 02 – Cadence On Time
This register can range from 1 to 6 in one-half seconds and controls the amount of "ring" time in the ring cadence. Factory preset
to 4 (2 seconds).
REGISTER 03- Cadence Off Time
This register can range from I to 15 in one-half seconds and controls the length of silent time between each ring. Factory preset
to 8 (4 seconds).

REGISTER 04 - Maximum Number of Rings to a Device

This register can range from 1 to 99 and controls the amount of rings sent to a device port. Factory preset to 8 rings.
0 (off)
1 (on)
0 (off)
0 (off)
0 (off)
1 (on)
0 (off)
0 (off)