Grizzly T28062 Owner's Manual page 11

Installing Collets
& Bits
The Model T28062 uses bits, burrs, and
mandrels with ⁄ " and
3
32
To use bits, burrs and mandrels with a
⁄ " diameter shaft, the
3
32
installed. To use bits, burrs and mandrels
with a ⁄ " diameter shaft, the
1
8
must be installed. The Model T28062
comes with an assortment of
and mandrels. See the Grizzly catalog or
website for a complete listing of available
bits and accessories.
Installing a Collet
1. DISCONNECT TOOL FROM POWER!
2. Press and hold spindle lock button
and turn knurled collet nut until spindle
locks.
3. While holding down spindle lock button,
loosen and remove knurled collet nut by
turning counterclockwise.
4. Insert collet into spindle, as shown in
Figure 3.
Collet
Knurled
Collet Nut
Figure 3. Inserting collet into spindle.
5. While holding down spindle lock button,
replace and tighten knurled collet nut
by turning clockwise. DO NOT over-
tighten.
Model T28062 (Mfd. Since 08/17)
⁄ " diameter shafts.
1
8
⁄ " collet must be
3
32
⁄ " collet
1
8
⁄ " bits, burrs
3
32
Spindle
Holding
Spindle
Lock
DO NOT use bits or cutters with a
cutting surface larger than 1". The
bit could break apart under the
stresses of high speed use caus-
ing serious personal injury.
Installing a Bit, Burr, or Mandrel
1. DISCONNECT TOOL FROM POWER!
2. Press and hold spindle lock button
and turn knurled collet nut until spindle
locks.
3. While holding down spindle lock but-
ton, loosen knurled collet nut by turning
counterclockwise.
Note: DO NOT completely remove
knurled collet nut from shaft.
4. Insert bit, burr, or mandrel shank into
collet, as seen in Figure 4.
Note: At least
mounted into end of collet.
Bit
Knurled
Collet Nut
Figure 4. Inserting bit into collet.
5. While holding down spindle lock but-
ton, tighten knurled collet nut by turning
clockwise. DO NOT over-tighten.
⁄ " of shank should be
1
2
Holding
Spindle
Spindle
Lock
-9
-