Adding A Transmitter Into The 7703 Radio Receiver - EMS 7940 IRIS+ Installation And Programming Instructions

EMS 7000 IRIS +
11.11 By using the "4" button to move left or the "6" button to move right, move to the
letter or number required and press the "5" button to select the character.
11.12 Repeat 11.11 until all letters have been selected. Once completed press
the " " button to save the information.
11.13 Once completed you may now escape from this menu by pressing the "3" button
on the keypad until the "SYSTEM RESET" message appears, or by returning the
key to the "CLEAR" position.
KEY
0 Enters a blank space into the new device name being entered.
3 Exits to the previous menu
4 Moves the alphabet wheel of characters to the Left, by one character
space at a time.
5 Enters the character in the centre directly above the character selector
|.
6 Moves the alphabet wheel of characters to the Right, by one character
space at a time.
7 Moves the flashing cursor to the left, through the new device name by
one character space at a time.
8 Moves the alphabet wheel of characters to the Right, by 12 character
Spaces at a time.
9 Moves the flashing cursor to the Right, through the new device name by
one character space at a time.
Backspace Key, Deletes by one character. (Deletes to the left only)
Saves and completes the current activity and returns the program to the
appropriate display.

12. Adding A Transmitter Into The 7703 Radio Receiver

12.1 The following
transmitter into the UHF 7703 Radio Receiver.
12.2 Turn the key on the 7703 receiver to the "RESET" position.
12.3 Turn the key to "TEST" and back to "RESET" three times. Allow not more than
one second between switching actions.
12.4 Wait until
transmitters onboard tamper switch.
12.5 The green Local LED will now flash and a buzzer sound.
12.6 Activate the tamper switch again.
and the buzzer will sound three times to acknowledge the transmitter has
been added into the system.
12.7 Repeat the above procedure for any further transmitters to be added.
sequence of
the red alarm
FUNCTION
operations is
LED starts flashing
The yellow Low Battery LED will light
19
required when
and then activate
7940 ENGINEERS GUIDE v2.2 – 13/04/10
adding a
the